![]() Usb 1-1: SN9C10 PC Camera Controller detected (vid/pid 0x0C45/0圆00D) Kernel: sn9c102: V4L2 driver for SN9C10x PC Camera Controllers v1:1.24a To check that your webcam is recognized, see the journal just after you plug the webcam in. Most recent webcams are UVC ( USB Video Class) compliant and are supported by the generic uvcvideo kernel driver module. dev/video0) are handled by udev, there is no configuration necessary. Permissions to access video devices (e.g. Most probably your webcam will work out of the box. You can log in to the device again.This is a guide to setting up your webcam. In this case, you can specify the target device, and then specify another Credentials at the top right of the screen. However, if multiple types of Credentials are mixed in the target system, it will remain in a state where communication cannot be performed for the devices that do not match the Credentials when you entered at the time of device detection. ("Credentials" is a general term for "User Name / Password" which is the device Administrator login qualification.)Įntering Credentials is performed on the screen at the time of device detection. Select the target device and execute in the at the top left of the screen.ģ) Authentication Information (Credentials) to be used for communication with the device To set up and maintain the devices by this software, this software needs to log in to each device. (Administrator information for the device) You can set the administrator information to the devices that the Administrator has not been registered yet by this software. Ģ) Authentication information to be registered for the devices of factory shipping state You can register it when this software is started up for the first time and also you can change it in the title bar ->. ![]() This software uses the following three kinds of the authentication information.ġ) Authentication information to be entered when this software is started up (Administrator information for this software)īefore you use this software for the first time, you need to register the authentication information for this software user. * You need to download the firmwares that you want to update on the devices from the our website in advance. Select the target device in the Device List, click on the left side of the screen, specify the folder where the firmware is/are saved, and automatically update the firmware on the target device. Save all the firmwares that you want to update on the devices in any folder (firmware in a storage folder) in advance. * You need to connect the PC to the Internet when you use this functionĢ) Batch upgrade by user-specified firmware (select folder) Then click, and you can automatically update the firmware on the target device. Click in the “Notification” screen and download the latest firmware from the our website. There are two ways to update: 1) Automatic confirmation of the latest firmware / Upgrade of all firmware and 2) Batch upgrade by user-specified firmware (select folder).ġ) Automatic confirmation of the latest firmware / Upgrade of all firmware If there is a newer version firmware than the current version firmware on the device, “Notification” is displayed. When updating the firmware in a system which various devices are mixed, you can update the firmware in a batch without considering the model number.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |